[ron_van_sommeren]

Ralph Okon (a.k.a. www.powerditto.de ) is putting together a group order for 40mm. diameter, 18pole statorlaminations. A minimum order of 5000 laminations is needed to start a production run. Minimum order per person is 50. One 0.20mm lamination (NO20 iron quality) will cost 0.5€. Flux ring and frontplates will probably also be available by then. Keep in mind, this is not a business for Ralph, he's in the business of curing people :(

More info on ordering;
http://www.rcgroups....ad.php?t=392627

I'll be posting this message in several lists/forums, think it's best if we all discussed/asked in the thread above.

[ron_van_sommeren]

Rahlp Okon a.ka. powerditto wrote:

Citeaza

I think, you should better calculate with ca. 4 per mm, because of the needed insulation between the plates. in summery 40 up to 45 per cm I think.

we are looking now for curved magnets for the project.
it seems, if there are enough users who join the project,
ist could give a complete set (can, bearings, etc.) for the motor.
lenght then 5, 10 and 15mm in first attempt.

and the baby has a name now:
its our "CROCODILE"

-has many teeth too, more then the others ;)
-seems to be leazy, but is a very powerfull animal.
- there are big elektrical lokomotives(?) for railway, also named so:
 http://www.ozdoba.net/rhb/croco_d.html

if you are interested in more details, please have a look at
www.powerditto.de/crocodile-project.html

we have orders for 2000statorplates now and we need minimum 5000 to get this very good price.....

viele grüsse,
ralph

www.powerditto.de

Aceasta postare a fost editata de ron_van_sommeren: 15 July 2005 - 04:27 PM

[ron_van_sommeren]

Turned parts, magnets, shafts, ball bearings will be available too. See:

English
http://www.rcgroups....ad.php?t=392627
http://www.powerditt...rojectengl.html

Deutsch
http://www.rclineforum.de/forum/thread.php...ghtuser=&page=4
http://www.powerditt...le-project.html

Remember, this is not a commercial thing, it's a group design project from the diy motor builders at
http://www.rclinefor....php?boardid=29

Aceasta postare a fost editata de ron_van_sommeren: 21 July 2005 - 02:55 PM

[ron_van_sommeren]

http://www.powerditto.de/crocodile-projekt/glocke2.jpg

[ron_van_sommeren]

Pre-ordering shafts, fluxring, mounting plate, drive plate, statorcarrier etc (English & German):
http://www.croco-power.de/